- Measure clearance between tire wall and radius arm at full lock. This must be.787" (20 mm).
- Loosen stop bolt locknut. (Scheme 2)
- Turn stop bolt as required.
- Tighten locknut.
- Check clearance between tire wall and radius arm on each lock.
Home/Land Rover/Discovery/Land Rover Discovery I (1989-1998)/Repair manual/Wheel Alignment/Checking & Adjusting
Contents
Section: Wheel Alignment- Riding Height Check
- Jacking & Hoisting
- Hydraulic Floor Jack
- Raising Front of Vehicle
- Raising Rear of Vehicle
- Hoist (two Post)
- Hoist (four Post)
- Visual Inspection
- Adjustments
- Steering Lock Stops
- Checking & Adjusting
- Alternate Checking & Adjusting (1990-95)
- Wheel Alignment Procedures
- Toe-In Adjustment
- Wheel Alignment Specifications
- Torque Specifications
- Abbreviations
- Airbag
- Anti-Lock/traction Control
- Automatic Trans
- Basic Trouble Shooting
- Brakes
- Check Lists
- Computer Relearn
- Diagnostic Connector Locations
- Driveline/axles
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Performance
- How to Overhaul & Installation the Engine Controls - Removal
- Identification
- MAP Guidelines
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Oem General Information
- Seats
- Specifications
- Steering
- Sun Roof/t-Top/convertible Top
- Testing & Diagnostics
- Traction Control Disable
- Transmission
- Wheel Alignment
- Windows
- Wiper/washer Systems
- Wiring Diagrams - Engine Performance
