Description
When reconnecting the battery cable after disconnecting, recharging battery after discharged or installing the memory fuse located on the driver's side panel after removing, be sure to reset systems mentioned in the below table.
In addition, when replacing or reinstalling their fuses after removing, they should be reset according to the below table. Please refer to the below table when servicing.
| System | Resetting |
|---|---|
| Auto up/down window | Whenever the battery is disconnected, discharged or the related fuse is replaced or reinstalled, reset the Auto up/down window system according to the procedure below. Turn the ignition switch to the ON position. Pull up the power window switch in order that the window can close completely, and then keep pulling up the power switch for about 1 second. |
| Sunroof | Whenever the battery is disconnected, discharged or the related fuse is replaced or reinstalled, the sunroof system must be reset according to the procedure below. Turn the ignition switch to the ON position. According to the position of the sunroof, do the following. In case the sunroof is closed completely or tilted: Push the sunroof control lever upward until the sunroof tilts completely upward. In case the sunroof is open: Push the sunroof control lever forward until the sunroof closes completely. Push the sunroof control lever upward until the sunroof tilts completely upward. Release the sunroof control lever. Push the sunroof control lever upward until the sunroof has returned to the original tilt position after it is raised a little higher than the maximum tilt position. Then, release the lever. Push the sunroof control lever upward until the sunroof operates as follows; TILT DOWN --> SLIDE OPEN --> SLIDE CLOSE Then, release the lever. |
| Trip computer | When the battery is disconnected and reconnected, the set functions of the trip computer become initialized. So, you need to explain this information to the customer. |
| Clock | Whenever the battery terminals or related fuses are disconnected, you must reset the time. When the ignition switch is in the ACC or ON position, the clock buttons operate as follows: Press the SETUP button for more than 1 second. If the audio is turned on, push the SETUP button and select the clock mode turning the TUNE knob. Adjust the hour and press the ENTER button to set. Use the same method to adjust the minute and press the ENTER button to complete. |
| Audio | When the battery is disconnected and reconnected, the customer's radio stations become initialized. So, you need to record the customer's radio stations prior to service, and after service, set the customer's radio stations into the audio. |