FRONT MUD GUARD AND WHEEL GUARD
Note. When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. Put on gloves to protect your hands. Take care not to scratch the body surface.
Scheme 90
- Remove the wheel guard, mud guard (A).
- Installation is the reverse of removal.
REAR MUD GUARD AND WHEEL GUARD
Note. When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. Put on gloves to protect your hands. Take care not to scratch the body surface.
Scheme 91
- Remove the wheel guard (A).
- Installation is the reverse of removal.
WHEN TO INITIALIZE THE MOTOR
- First operation the vehicle after manufacture it.
- Initial value is erased or damaged because of short power electric discharge during operation.
- After using the manual handle.
Scheme 92
- Use the sunroof emergency handle to close and open the sunroof manually for the following case only. To close the sunroof before driving a vehicle in a rainy day or on the highway if the sunroof cannot be closed due to failure of the sunroof motor or controller.
- Operating method. Remove the overhead console. Push the emergency handle up into the hexagonal drive (A) of the sunroof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor. Carefully turn the emergency handle clockwise to close the sunroof. After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages. A 5mm hex socket may be used in place of the emergency handle, with a "Speeder" type handle. CAUTION: Do not use power tools to operate the sunroof. Damage to the components may occur.