Calibration Procedure
If the compass has been calibrated or set to variance zone number incorrectly or you are driving in specific places (tunnel, parking lot in building, underground parking lot, near transformer substation, etc.), the below conditions may occur.
- The display read "C".
- The compass headings become inaccurate.
- The compass heading is not changed.
- Some compass headings are not displayed.
- The compass headings are inaccurate in long distance driving.
This compass automatically calibrates itself while the vehicle is driven as your route takes you in complete circles.
If the vehicle's compass headings become inaccurate continuously, the compass should be manually calibrated as follows
- Move the vehicle from the large steel structure or electric power supply cable.
- Turn on the compass by pressing the A button.
- Check the zone number by pressing the A button for more than 4 seconds until the current zone number appears in the display. To re-calibrate, hold the A button for 3 seconds until C is displayed. If the zone number is different for your country, set the correct zone number referring to " «SETTING THE COMPASS ZONE»(ref-675263-S39993244622014120400000) " and do the " «CALIBRATION PROCEDURE»(ref-675263-S07526036172014120400000) " again.
- Drive your vehicle in at least 2 circles at less than 5 miles per hour (8 km/h) until the compass heading appears. Driving in a circle in right-handed direction and opposite direction is possible and if possible, stops the wiper operation.
- If the vehicle's compass headings become inaccurate as before, do the following procedure again. NOTE: If new vehicle is first driven or if the battery has been disconnected, do the calibration procedure as above.