Home ReviewsRefund Car not listed?
Home/Kia/Optima/Kia Optima III (2010-2013)/Repair manual/Communication Devices/Body Control Module Diagnosis - Except Hev: Other
Contents Wiring diagrams Section: Communication Devices All sections

Body Control Module Diagnosis - Except Hev: Other Kia Optima III

Communication Devices 4 illustrations ~300 words

Verification Of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect scan tool and select "DTC Analysis" mode.
  2. Clear the DTCs and Operate the vehicle within DTC Enable conditions in General information.
  3. Is any DTC outputted again? YES Go to the applicable troubleshooting procedure. NO System performing to specification at this time.

Scheme 58

Scheme 58: Component Location
Scheme 58: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect scan tool and select "DTC Analysis" mode.
  2. Clear the DTCs and Operate the vehicle within DTC Enable conditions in General information.
  3. Is any DTC outputted again? YES Go to the applicable troubleshooting procedure. NO System performing to specification at this time.

Scheme 59

Scheme 59: Component Location
Scheme 59: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect scan tool and select "DTC Analysis" mode.
  2. Clear the DTCs and Operate the vehicle within DTC Enable conditions in General information.
  3. Is any DTC outputted again? YES Go to the applicable troubleshooting procedure. NO System performing to specification at this time.

Scheme 60

Scheme 60: Component Location
Scheme 60: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect scan tool and select "DTC Analysis" mode.
  2. Clear the DTCs and Operate the vehicle within DTC Enable conditions in General information.
  3. Is any DTC outputted again? YES Go to the applicable troubleshooting procedure. NO System performing to specification at this time.

Scheme 61

Scheme 61: Component Location
Scheme 61: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect scan tool and select "DTC Analysis" mode.
  2. Clear the DTCs and Operate the vehicle within DTC Enable conditions in General information.
  3. Is any DTC outputted again? YES Go to the applicable troubleshooting procedure. NO System performing to specification at this time.

More articles — Body Control Module Diagnosis - Except Hev