REMOVAL & INSTALLATION
Note. Any time battery cables are disconnected from battery and then reconnected, theft deterrent system will be activated (horn will sound and emergency lights will flash about 3 minutes). To disarm theft deterrent system, insert ignition key and turn it to ACC position.
- Disconnect negative battery cable. Remove 2 upper bolts from intake manifold bracket. Raise and support vehicle. On M/T, remove clutch slave cylinder and push it aside.
- On all models, remove lower intake manifold bracket bolts and bracket. Remove 2 upper starter bolts and a lower bolt. Pull starter from clutch (M/T) or converter (A/T) housing and prop in place. From above, disconnect starter solenoid "S" and "B" terminal connectors. From below, push transmission harness aside and remove starter.
- To install, reverse removal procedure. Rotate starter to provide proper clearance. Tighten all nuts and bolts to specification. See «TORQUE SPECIFICATIONS»(ref-99681-S04849036622001072600000) .
