DIAGNOSIS AND TESTING - BODY CONTROL MODULE
| WARNING | ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, DRIVER AIRBAG, PASSENGER AIRBAG, SEAT BELT TENSIONER, FRONT IMPACT SENSORS, SIDE CURTAIN AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. SEE AIR BAG RESTRAINT SYSTEMS ARTICLE FOR DISABLING AND ENABLING PROCEDURES. |
The hard wired inputs to and outputs from the Body Control Module (BCM), as well as other hard wired circuits for this module may be diagnosed and tested using conventional diagnostic tools and procedures. However, conventional diagnostic methods may not prove conclusive in the diagnosis of the BCM, the Programmable Communications Interface (PCI) data bus network, or the electronic messages received and transmitted by the BCM over the PCI data bus. The most reliable, efficient, and accurate means to diagnose the BCM and the PCI data bus network inputs to and outputs from this module requires the use of a DRBIII(R) scan tool. Refer to the appropriate diagnostic information.
DIAGNOSIS AND TESTING - HEATED SEAT MODULE
If a heated seat fails to heat and one or both of the indicator lamps on a heated seat switch flash, refer to POWER & HEATED SEATS article for flashing LED failure identification. See POWER SEATS in SYSTEM WIRING DIAGRAMS article for complete heated seat system wiring diagrams.