This monitor runs continuously. The voltage from the sensor is compared with failure thresholds defined in the software. If the sensor voltage is less than the minimum threshold, a timer will be started. If this timer exceeds a threshold, a failure flag is set and a DTC is stored. If the sensor voltage is greater than the maximum threshold, a timer will be started. If this timer exceeds a threshold, a failure flag is set and a DTC is stored.
Contents
Wiring diagrams Section: Testing & Diagnostics All sections- A/c Compressor
- Abbreviations
- Accessory Drive Belts
- Airbag
- Anti-Lock/traction Control
- Automatic HVAC System
- Automatic Trans
- Basic Trouble Shooting
- Blowers, Superchargers & Turbochargers
- Brakes
- Brakes Control Systems
- Cabin Air Filter
- Charging System
- Check Lists
- Collision/avoidance
- Communication Devices
- Cooling Fan
- Cruise Control Systems
- Diagnostic Connector Locations
- Differentials & Drive Axles
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- Driveshaft & Universal Joints
- DTC Index
- Electrical
- Electrical Component Locations
- Electronic Suspension
- Emission Applications
- Engine
- Engine Control Systems
- Engine Performance
- Entertainment Systems
- Exhaust
- Exterior Body Panels
- Exterior Lights
- Exterior/interior Trim
- Frames, Subframes & Crossmembers
- Fuel System
- Gauges & Instrument Panels
- Heated Glass/defoggers
- Hoist/jack
- Horns
- Identification
- Ignition System
- Interior/illumination Lights
- Manual & Power Steering
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mode 6
- Navigation System
- Oem General Information
- Passive Restraints
- Reset Procedures
- Seats
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Steering Linkage
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Traction Control Disable
- Transmission
- Warning System
- Wheel & Tire System
- Windows
- Wiper/washer Systems
- Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.)
