Glass, Frames and Mechanisms: Other Jaguar X-type I рестайлинг

Door Window Motor Initialization - General Procedures

1. Operate the window control switch until the door window glass is in the fully closed position, continue to operate the window control switch for a further two seconds.
2. Release the window control switch.
3. Operate the window control switch in the closed position and continue to operate the window control switch for a further two seconds.
4. Operate the window control switch until the door window glass is in the fully open position ("one-touch" down).
5. Operate the window control switch once to the close position.
6. Repeat the door window motor initialization for each door window motor.

Scheme 89

Scheme 90

Scheme 91

Scheme 92

1. Make sure the rear wiper mounting arm is in the parked position.
2. Open the liftgate window glass.
3. Open the liftgate.
4. Remove the liftgate trim panel. Refer to «Liftgate Trim Panel»(ref-311913-S38304203632009040700000) article.
5. Loosen the rear wiper motor retaining nuts.
6. Close the liftgate.
7. Make sure the liftgate glass latch and rear wiper mounting arm locate correctly into the liftgate latch actuator and rear wiper motor.
8. Close the liftgate glass.
9. Tighten the rear wiper retaining bolts in the order shown. Tighten to 8 Nm.
10. Visually check the liftgate window glass for correct alignment.
11. Install the liftgate trim panel. Refer to «Liftgate Trim Panel»(ref-311913-S38304203632009040700000) article.

Scheme 93

Scheme 94

Scheme 95

1. Lower the front door window glass approximately 290 mm (11.41 in).
2. Remove the front door trim panel. Refer to «Front Door Trim Panel»(ref-311913) article.
3. Detach the front door weather shield.
4. Remove the front door window glass. Loosen the retaining bolts.

Scheme 96

1. Install the front door window glass, but do not tighten the retaining bolts.
2. Connect the window control switch electrical connector.
3. Power the front door window glass to the fully closed position.
4. Tighten to 8 Nm.
5. Attach the front door weather shield.
6. Install the front door trim panel. Refer to «Front Door Trim Panel»(ref-311913) article.

Scheme 97

Scheme 98

1. Remove the front door window glass. See «Front Door Window Glass»(ref-311915-S11716144942009040700000) .
2. Disconnect the electrical connector.
3. Remove the front door motor and window regulator.