Home/Isuzu/Oasis/Isuzu Oasis I (1995-1999)/Repair manual/Procedures/Maintenance Information: Specifications
Contents Wiring diagrams Section: Procedures All sections

Maintenance Information: Specifications Isuzu Oasis I

LUBRICATION SPECIFICATIONS

MaterialConditionSpecification
Engine Oil (1)Ambient Temperature Down To -20°F (-30°C) To Over 100°F (40°C)SAE 5W-30
Engine Oil (1)Ambient Temperature Over Than 20°F (-7°C)SAE 10W-30
Engine CoolantAll50/50 Mixture Distilled Water Ethylene Glycol
Power Steering FluidAllHonda Power Steering Fluid
Brake FluidAllDOT 3 or DOT 4
Automatic Transmission FluidAllDEXRON III
A/C RefrigerantAllR-134a
A/C LubricantAllND-OIL8
(1) SAE 5W-30 is preferred, use oils displaying the API certification mark with the Starburst Symbol.
(1)SAE 5W-30 is preferred, use oils displaying the API certification mark with the Starburst Symbol.

LUBRICATION SPECIFICATIONS

FLUID CAPACITIES

ItemConditionSpecification (1)
Engine Oil2.2L: Drained, With Filter3.7 Qts. (3.5L)
Engine Coolant2.2L: Drained6.7 Qts. (6.3L)
Transmission Fluid2.2L: Capacity2.5 Qts. (2.4L)
Fuel TankCapacity17.2 Gal. (65.0L)
Windshield Washer ReservoirAll2.6 Qts. (2.5L)
(1) Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level.
(1)Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level.

FLUID CAPACITIES

WHEEL & TIRE SPECIFICATIONS

Wheel and tire information can be found on label attached to edge of driver's door.

WHEEL TIGHTENING

Tighten wheel lug nuts to 80 ft. lbs. (110 N.m).

BATTERY SPECIFICATIONS

CAUTIONWhen battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION section.

If battery is replaced, new battery should be of the same group number as shown on the original battery's label.