DESCRIPTION
Electric fuel pump is mounted under the right rear side of vehicle near the fuel tank. No internal pump components are serviceable and entire pump should be replaced if found defective.
PRESSURE TEST
| CAUTION | The fuel line is under pressure. When installing an in-line fuel pressure gauge, caution must be used when disconnecting fuel lines. |
- Install fuel pressure gauge between the pressure regulator and fuel distributor pipe. Unplug the vacuum switching valve at the connector.
- Vacuum switching valve is located on right side fender below ignition coil. Start engine and measure fuel pressure. Pressure should be 28.4 psi (2.0 kg/cm 2 ).
Removal & Installation
Remove rear seat assembly. Unplug electrical harness at terminal located under right side part of rear seat. Disconnect hoses from fuel pump. Remove the pump guard. Remove pump from bracket. Install in reverse order of removal.