Infiniti Q45 II (1996-2001) tach signal input wiring diagram
This page shows the only wiring diagram for the component.tach signal input, which is found in the car Infiniti Q45 II (1996-2001). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
tach signal input wiring diagram (1 of 1)
1 2 3 4 6 7 8 9 10 12 13 14 15 16 17 18 19 20 101 103 107 108 110 GND-A
127 73 66 61 52 99 129 GND-C TCS SW STPS
ABS ACTUATOR (RIGHT REAR OF ENGINE COMPT, BEHIND STRUT TOWER)
ABS IND.
BLK WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU WIRE
BLU/BLK WIRE
BLU/RED WIRE
BLU/WHT WIRE
BRN WIRE
BRN/WHT WIRE
BRN/YEL WIRE
COMBINATION METER
COMPUTER DATA LINES SYSTEM
DIODE
ECM (ECCS) CONTROL MODULE (RIGHT KICK PANEL)
GRN WIRE
GRN/ WHT WIRE
GRN/ORG WIRE
GRN/RED WIRE
GRY WIRE
JOINT CONNECTOR 1 (BEHIND LEFT SIDE OF DASH)
JOINT CONNECTOR 8 (BEHIND LEFT KICK PANEL)
LT BLU WIRE
LT GRN WIRE
LT GRN/RED WIRE
MOTOR RELAY
NCA WIRE
ORG/BLK WIRE
PNK WIRE
PPL
RED WIRE
RED/BLU WIRE
SECONDARY THROTTLE POSITION SENSOR (ON THROTTLE BODY)
SLIP IND
SOLENOID VALVE RELAY
TAC MODULE (BEHIND RIGHT KICK PANEL)
TACH SIGNAL INPUT
TACHO LAN GND-A
TCS OFF IND
THROTTLE MOTOR (ON THROTTLE BODY)
TRANSMISSIONS SYSTEM
WHT WIRE
WHT/GRN WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> Anti-lock brake circuits (2 of 2) -> TACH SIGNAL INPUT
