APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
| Diagnosis mode | Function Description |
|---|---|
| Work Support | Changes the setting for each system function. |
| Self Diagnostic Result | Displays the diagnosis results judged by BCM. |
| CAN DIAG SUPPORT MNTR | Monitors the reception status of CAN communication viewed from BCM. Refer to the CONSULT-III operation instructions. |
| Data Monitor | The BCM input/output signals are displayed. |
| Active Test | The signals used to activate each device are forcibly supplied from BCM. |
| Ecu Identification | The BCM part number is displayed. |
| Configuration | This function is not used even though it is displayed. |
DIAGNOSIS MODE DESCRIPTION
SYSTEM APPLICATION
BCM can perform the following functions for each system.
Note. It can perform the diagnosis modes except the following for all sub system selection items.
| System | Sub system selection item | Diagnosis mode | ||
|---|---|---|---|---|
| Work Support | Data Monitor | Active Test | ||
| Door lock | DOOR LOCK | X | X | X |
| Rear window defogger | REAR DEFOGGER | X | X | |
| Warning chime | BUZZER | X | X | |
| Interior room lamp timer | INT LAMP | X | X | X |
| Exterior lamp | HEAD LAMP | X | X | X |
| Wiper and washer | WIPER | X | X | X |
| Turn signal and hazard warning lamps | FLASHER | X | X | X |
| Air conditioner (1) | AIR CONDITONER | X | ||
| Intelligent Key system | INTELLIGENT KEY | X | X | X |
| Combination switch | COMB SW | X | ||
| BCM | BCM | X | ||
| IVIS - NATS | IMMU | X | X | |
| Interior room lamp battery saver | BATTERY SAVER | X | X | X |
| Trunk open | TRUNK | X | ||
| Vehicle security system | THEFT ALM | X | X | X |
| RAP system | RETAINED PWR | X | ||
| Signal buffer system | SIGNAL BUFFER | X | X | |
| TPMS | TPMS (AIR PRESSURE MONITOR) | X | X | X |
| (1) This item is displayed, but is not used. | ||||
| (1) | This item is displayed, but is not used. |
SYSTEM REFERENCE