Home/Infiniti/I35/Infiniti I35 II (2000-2004)/Repair manual/Engine Controls - Self-Diagnostics - Maxima & I35: Diagnosis/Checking SRT Code Status (Using Generic Scan Tool)

Contents

Wiring diagrams Section: Engine Controls - Self-Diagnostics - Maxima & I35: Diagnosis

ON-BOARD DIAGNOSTICS

TESTING PROCEDURE

Using Scan Tool

Diagnostic Test Mode II (Self-Diagnostic Results)

Diagnostic Test Mode II (Front HO2S Monitor)

Entering Diagnostic Test Mode II (Self-Diagnostic Results Mode)

Entering Diagnostic Test Mode II (Front HO2S Monitoring)

CLEARING DIAGNOSTIC TROUBLE CODES

Using Generic Scan Tool

Checking SRT Code Status (Using Generic Scan Tool)

Setting SRT Codes (Using Generic Scan Tool)

Entering Diagnostic Test Modes

Active Test Mode

GENERIC SCAN TOOL

Mode 1: Readiness Test

Mode 3: Diagnostic Trouble Codes (DTCs)

Mode 8: EVAP System Testing

DIAGNOSTIC TROUBLE CODE DEFINITIONS

DTC Confirmation Test

Diagnostic Procedure (I35)

Diagnostic Procedure (Maxima)

Possible Causes - DTC P0031 (Bank 1) Or DTC P0051 (Bank 2)

Possible Causes - DTC P0032 (Bank 1) Or DTC P0052 (Bank 2)

DTC Confirmation Test (Using CONSULT-II)

DTC Confirmation Test (Using Generic Scan Tool)

Diagnostic Procedure

Possible Causes - DTC P0037 (Bank 1) Or DTC P0057 (Bank 2)

Possible Causes - DTC P0038 (Bank 1) Or DTC P0058 (Bank 2)

DTC Confirmation Test "A"

DTC Confirmation Test "B" (Using CONSULT-II)

DTC Confirmation Test "B" (Using Generic Scan Tool)

Possible Causes (DTC P0102)

Possible Causes (DTC P0103)

Fail-Safe Mode

DTC Confirmation Test "B"

DTC Confirmation Test "C"

DTC Confirmation Test "A" & "B"

DTC Confirmation Test (DTC P1124)

DTC Confirmation Test (DTC P1126)

All sections

Checking SRT Code Status (Using Generic Scan Tool) Infiniti I35 II

Engine Controls - Self-Diagnostics - Maxima & I35: Diagnosis

Checking SRT Code Status (Using Generic Scan Tool)

Select MODE 1 with scan tool, and observe SRT STATUS. An INCMP display for any SRT system indicates the self-diagnosis for that circuit is incomplete. SRT systems that have completed self-diagnosis will be indicated by CMPLT, indicating SRT is set. If any category is incomplete, go to SETTING SRT CODES.