RIDING HEIGHT ADJUSTMENT
Note. For wheel alignment specifications and procedures on QX4, refer to Pathfinder in Nissan SPECIFICATIONS & PROCEDURES article.
Note. Prior to performing wheel alignment, perform preliminary visual and mechanical inspection of wheels, tires, and suspension components. See PRE-ALIGNMENT INSTRUCTIONS in WHEEL ALIGNMENT THEORY & OPERATION in appropriate GENERAL INFORMATION article.
Before adjusting alignment, measure riding height. Riding height must be measured with vehicle on level floor, tires properly inflated, and with no treadwear indicators showing. Ensure fuel tank, radiator, and crankcase are full. Ensure spare tire, jack, hand tools, and floor mats are in proper positions. Bounce vehicle several times and allow suspension to settle.
Visually inspect vehicle for signs of abnormal height from front to rear or side to side. Check passenger and luggage compartments for heavy items (remove them if present). If riding height is not within specification, inspect and repair or replace suspension components. See RIDING HEIGHT SPECIFICATIONS table.
| Application | Front - In. (mm) | Rear - In. (mm) | |
|---|---|---|---|
| G20 | |||
| With 195/60 R15 Tires | 26.22 (666) | 25.71 (653) | |
| With 195/65 R15 Tires | 26.42 (671) | 25.91 (658) | |
| I30 | |||
| With 205/65 R15 Tires | 28.07 (713) | 28.15 (715) | |
| With 215/55 R16 Tires | 27.48 (698) | 26.89 (683) | |
| With 215/60 R15 Tires | 28.07 (713) | 28.07 (713) | |
| With 225/50 R17 Tires | 27.80 (706) | 27.32 (694) | |
| Q45 | |||
| With 215/60 R16 Tires | 28.78 (731) | 28.90 (734) | |
| With 225/50 R17 Tires | 28.43 (722) | 28.46 (723) | |
| (1) Measure riding height from top of wheelwell to ground. | |||
| (1) | Measure riding height from top of wheelwell to ground. |
RIDING HEIGHT SPECIFICATIONS (1)
CAMBER ADJUSTMENT
Note. Front camber is not adjustable on G20, I30 and Q45 models. Rear camber is not adjustable on G20 and I30 models. Inspect and replace any damaged or worn components.
TOE-IN ADJUSTMENT
Note. Rear toe-in is not adjustable on G20 and I30 models. Inspect and replace any damaged or worn components.