CONSULT APPLICATION ITEMS
CONSULT can perform the following diagnosis modes with CAN communication with the unified meter and A/C amp
| System | Diagnosis mode | Description |
|---|
| METER/M&A | Self Diagnostic Result | Unified meter and A/C amp. checks the conditions and displays memorized error. |
| Data Monitor | Displays unified meter and A/C amp. input/output data in real time. |
| ECU Identification | The unified meter and A/C amp. part number is displayed. |
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM
| Diagnosis mode | Function Description |
|---|
| Work Support | Changes the setting for each system function. |
| Self Diagnostic Result | Displays the diagnosis results judged by BCM. |
| CAN Diag Support Monitor | Monitors the reception status of CAN communication viewed from BCM. |
| Data Monitor | The BCM input/output signals are displayed. |
| Active Test | The signals used to activate each device are forcibly supplied from BCM. |
| ECU Identification | The BCM part number is displayed. |
| Configuration | Read and save the vehicle specification. Write the vehicle specification when replacing BCM. |
SYSTEM APPLICATION
BCM can perform the following functions for each system
Note. It can perform the diagnosis modes except the following for all sub system selection items
| X: Applicable item |
|---|
| System | Sub system selection item | Diagnosis mode |
| Work Support | Data Monitor | Active Test |
| Door lock | DOOR LOCK | X | X | X |
| Rear window defogger | REAR DEFOGGER | | X | X |
| Warning chime | BUZZER | | X | X |
| Interior room lamp timer | INT LAMP | X | X | X |
| Exterior lamp | HEAD LAMP | X | X | X |
| Wiper and washer | WIPER | X | X | X |
| Turn signal and hazard warning lamps | FLASHER | X | X | X |
| AIR CONDITONER (1) | | | |
| Intelligent Key system Engine start system | INTELLIGENT KEY | X | X | X |
| Combination switch | COMB SW | | X | |
| Body control system | BCM | X | | |
| IVIS - NATS | IMMU | | X | X |
| Interior room lamp battery saver | BATTERY SAVER | X | X | X |
| Back door open | TRUNK | | X | X |
| Vehicle security system | THEFT ALM | X | X | X |
| RAP system | RETAINED PWR | | X | |
| Signal buffer system | SIGNAL BUFFER | | X | X |
| NOTE: (1) This item is displayed, but is not used. |
| NOTE |
|---|
| (1) This item is displayed, but is not used. |
| (1) | This item is displayed, but is not used. |
| Test item | Diagnosis mode | Description |
|---|
| BUZZER | Data Monitor | Displays BCM input data in real time. |
| Active Test | Operation of electrical loads can be checked by sending driving signal to them. |
