Home ReviewsRefund
Home/Infiniti/FX50/Infiniti FX50 II (2008-2012)/Repair manual/Procedures/Maintenance: Removal & Installation
Contents Wiring diagrams Section: Procedures All sections

Maintenance: Removal & Installation Infiniti FX50 II

Procedures 5 illustrations ~228 words

INSTALLATION

Note the following item, and install in the reverse order of removal.

  1. Install the air cleaner filter by aligning the seal with the notch of air cleaner case.

REMOVAL

CAUTIONOil filter is provided with relief valve. Use genuine NISSAN oil filter or an equivalent. Be careful not to get burned when engine and engine oil may be hot. When removing, prepare a shop cloth to absorb any engine oil leakage or spillage. Never allow engine oil to adhere to drive belt. Completely wipe off any engine oil that adheres to engine and vehicle.

Scheme 12

Scheme 12
Scheme 12

Scheme 13

Scheme 13
Scheme 13
  1. Remove engine undercover with power tool.
  2. Using oil filter wrench [SST: KV10115801 (J38956)] (B), remove oil filter.

Scheme 14

Scheme 14: INSTALLATION
Scheme 14: INSTALLATION

Scheme 15

Scheme 15
Scheme 15
  1. Remove foreign matter adhering to oil filter installation surface.
  2. Apply engine oil to the oil seal contact surface of new oil filter.
  3. Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn (A). Or tighten to the specification. Oil filter: Torque Specifications: 17.7 N.m (1.8 kg-m, 13 ft-lb)

Installation is the reverse order of removal.

Note the following item, and install in the reverse order of removal.

  1. Install the air cleaner filter by aligning the seal with the notch of air cleaner case.
CAUTIONOil filter is provided with relief valve. Use genuine NISSAN oil filter or an equivalent. Be careful not to get burned when engine and engine oil may be hot. When removing, prepare a shop cloth to absorb any engine oil leakage or spillage. Never allow engine oil to adhere to drive belts. Completely wipe off any engine oil that adheres to engine and vehicle.

Scheme 16

Scheme 16
Scheme 16
  1. Remove engine undercover with power tool.
  2. Using oil filter wrench [SST: KV10115801 (J38956)] (A), remove oil filter.
  1. Remove foreign matter adhering to oil filter installation surface.
  2. Apply engine oil to the oil seal contact surface of new oil filter.
  3. Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn (A). Or tighten to the specification. Oil filter: Torque Specifications: 17.7 N.m (1.8 kg-m, 13 ft-lb)

Installation is the reverse order of removal.

More articles — Maintenance