Checking
| WARNING | Be sure to perform the these steps when engine is stopped. |
- Remove air duct (inlet) when inspecting alternator, water pump and A/C compressor belt.
- Remove engine undercover with power tool when inspecting power steering oil pump belt.
- Check that the indicator (A) (notch on fixed side) of each auto-tensioner is within the possible use range (B). NOTE: Check the each auto-tensioners indication when the engine is cold. When new drive belts is installed, the indicator (notch on fixed side) should be within the range (C) shown above.
- Visually check all drive belts for wear, damage or cracks.
- If the indicator (notch on fixed side) is out of the possible use range or drive belts are damaged, replace drive belts.