Home ReviewsRefund
Home/Infiniti/FX50/Infiniti FX50 II (2008-2012)/Repair manual/Engine Control Systems/Accelerator Control System: Removal & Installation
Contents Wiring diagrams Section: Engine Control Systems All sections

Accelerator Control System: Removal & Installation Infiniti FX50 II

Engine Control Systems ~127 words

REMOVAL

  1. Remove the bolt cap and the inside mounting bolt.
  2. Remove accelerator pedal assembly.
  3. Disconnect accelerator pedal position sensor harness connector. CAUTION: Never disassemble accelerator lever. Never remove accelerator pedal position sensor from accelerator lever. Avoid impact from dropping etc. during handling. Be careful to keep accelerator lever away from water.

INSTALLATION

Installation is the reverse order of removal.

  1. Remove mounting screw, and then remove accelerator pedal assembly. CAUTION: Never disassemble accelerator pedal assembly. Never remove accelerator pedal position sensor from accelerator pedal assembly. Avoid impact from dropping etc. during handling. Be careful to keep accelerator pedal assembly away from water.
  2. Disconnect accelerator pedal actuator harness connector and accelerator pedal position sensor harness connector.

Installation is the reverse order of removal.

More articles — Accelerator Control System