Home ReviewsRefund Car not listed?
Home/Hyundai/Tucson/Hyundai Tucson II (2009-2015)/Repair manual/Communication Devices/Smart Key - Smart Key Code Saving Diagnosis: Other
Contents Wiring diagrams Section: Communication Devices All sections

Smart Key - Smart Key Code Saving Diagnosis: Other Hyundai Tucson II

Communication Devices 4 illustrations ~381 words

Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, ECM status and Smartkey ECM status
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 250

Scheme 250: Component Location
Scheme 250: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, ECM status and Smartkey ECM status.
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 251

Scheme 251: Component Location
Scheme 251: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, ECM status and Smartkey ECM status
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 252

Scheme 252: Component Location
Scheme 252: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, ECM status and Smartkey ECM status
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 253

Scheme 253: Component Location
Scheme 253: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, ECM status and Smartkey ECM status
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

More articles — Smart Key - Smart Key Code Saving Diagnosis