Home/Hyundai/Santa Fe/Hyundai Santa Fe II рестайлинг (2010-2012)/Repair manual/Engine Control System - g3.5 DOHC/Installation

Contents

Section: Engine Control System - g3.5 DOHC

General information

ECM Terminal Function

ECM Terminal Input/Output Signal

Removal

Installation

ECM Problem Inspection Procedure

VIN Programming Procedure

Description

Fail-Safe Mode

Specification

Throttle Position Sensor (TPS)

ETC Motor

Inspection

All sections

Installation Hyundai Santa Fe II рестайлинг

Engine Control System - g3.5 DOHC

Installation

Note. In the case of the vehicle equipped with immobilizer, perform "Key Teaching" procedure. (Refer to TEACHING PROCEDURES .)

Installation is reverse of removal. ECM installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft) ECM bracket installation bolt/nut: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)