Shift Lock Control: Removal & Installation Hummer H2 I рестайлинг

Removal Procedure

1. Remove the console. Refer to «Front Floor Console Replacement»(ref-299121-S40892247102008092200000) .
2. Disconnect the shift lock actuator electrical connector (3).
3. Shift assembly to LOW position.
4. Loosen and remove the screw at the rear of the shifter assembly.
5. Shift the assembly to the NEUTRAL position.
6. Loosen and remove the top screw of the shift lock actuator through the lever slot.
7. Pull lever to the DRIVE position and remove the shift lock actuator.

Installation Procedure

1. In the DRIVE position, depress the shift lock actuator button and realign into the shifter lever.
2. Push lever to NEUTRAL.
3. Install the top screw through the lever slot. Tighten: Tighten the actuator screw to 1.65 N.m (15 lb in).
4. Shift lever to LOW.
5. Install the screw at the rear of the shifter assembly. Tighten: Tighten the actuator screw to 1.65 N.m (15 lb in).
6. Connect the electrical connector (3).
7. Install the console. Refer to «Front Floor Console Replacement»(ref-299121-S40892247102008092200000) .

The automatic transmission shift lock control system is a safety device that prevents an inadvertent shift out of PARK when the engine is running. The driver must press the brake pedal before moving the shift lever out of the PARK position. The system consists of the following components

1. The automatic transmission shift lock solenoid (serviced as the automatic transmission shift lock actuator), as well as the body control module (BCM) and the engine control module (ECM). The shift lock solenoid is located within the floor shift control assembly with vehicles equipped with floor shift.
2. The body control module (BCM) controls the voltage supply circuit of the shift lock control solenoid. The following conditions must be before the BCM will remove voltage from the shift lock control solenoid.

The BCM controls the voltage to the shift lock control solenoid through the shift lock control solenoid controlled voltage circuit. The following conditions must be met before the BCM will remove voltage from the shift lock solenoid

1. The ignition is in the ON position.
2. The engine control module (ECM) sends an input via GMLAN serial data to the BCM indicating the transmission is in the PARK position.
3. The BCM determines the brake pedal is applied according the brake pedal position.

Since the shift lock control solenoid is permanently grounded, the BCM supplies voltage to the automatic transmission shift lock control solenoid, mechanically locking the shift lever preventing the driver from moving the shift lever out of the PARK position as the solenoid energizes. When the brake pedal is not applied, the BCM turns the control voltage output of the shift lock control solenoid ON, energizing the shift lock control solenoid. The energized solenoid mechanically locks the shift lever in the PARK position.

During remote start operation, the BCM will energize the shift lock control circuit, locking the shift lever in the PARK position.