Home ReviewsRefund
Home/Honda/Pilot/Honda Pilot I рестайлинг (2005-2008)/Repair manual/Ignition Switch/steering Lock/Ignition Switch (Test)
Contents Section: Ignition Switch/steering Lock All sections

Ignition Switch (Test) Honda Pilot I рестайлинг

Ignition Switch/steering Lock 2 illustrations ~169 words

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before performing repairs or service.

Scheme 1

Scheme 1: Test
Scheme 1: Test

Scheme 2

Scheme 2
Scheme 2
  1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.
  2. Disconnect the negative battery cable.
  3. Remove the driver's dashboard lower cover (see «INSTRUMENT PANEL REMOVAL/ INSTALLATION»(/honda/pilot/i-2005-2008/remont/exteriorinterior-trim/#dashboard__instrument-panel-removalinstallation) ).
  4. Disconnect the 6P connector from the driver's under-dash fuse/relay box.
  5. Check for continuity between the terminals in each switch position according to the table.
  6. If the continuity checks do not agree with the table, replace the steering lock.
  7. After reconnecting the battery, enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station presets, and set the clock. (on vehicles without navigation).
  8. Reset the power window control unit (see «RESETTING THE POWER WINDOW CONTROL UNIT»(ref-243312-S03263640362006082300000) ).