Numbers or bars have been stamped on the side of each connecting rod as a code for the size of the big end. Use them, and the letters or bars stamped on the crank (codes for rod journal size), to choose the correct bearings. If the codes are indecipherable because of an accumulation of dirt and dust, do not scrub them with a wire brush or scraper. Clean them only with solvent or detergent.
Home/Honda/Pilot/Honda Pilot I (2002-2005)/Repair manual/Mechanical/Connecting Rod Journal Code Locations
Contents
Wiring diagrams Section: Mechanical All sections- Abbreviations
- Accessory Drive Belts
- Airbag
- Anti-Lock/traction Control
- Automatic HVAC System
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Basic Trouble Shooting
- Body Electrical
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Communication Devices
- Computer Relearn
- Cooling Fan
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Differentials & Drive Axles
- Door Locks & Anti-Theft Systems
- Driveline/axles
- Driveshaft & Universal Joints
- DTC Index
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Performance
- Entertainment Systems
- Exhaust
- Exterior Lights
- Exterior/interior Trim
- Fuel System
- Gauges & Instrument Panels
- Heated Glass/defoggers
- Hoist/jack
- Horns
- Identification
- Ignition Switch/steering Lock
- Ignition System
- Interior/illumination Lights
- Lubrication System
- Manual HVAC System
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Mode 6
- Navigation System
- Oem General Information
- Reset Procedures
- Restraints
- Restraints Control Systems
- Seats
- Specifications
- Starter
- Steering
- Steering Column Switches
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Timing Belt
- Transfer Case
- Transmission
- Wheel Alignment
- Windows
- Wiper/washer Systems
