Reading the sub code Honda Element YH2

Reading the sub code

Count the number of blinks.

Example

Scheme 206

If the main code is `3', and the sub code is `4', record a DTC 3-4.

1. Including the most recent problem, up to three different DTCs can be indicated (see example 1).
2. In case of a continuous failure, the DTC will be indicated repeatedly (see example 1).
3. In case of an intermittent failure, the SRS indicator will indicate the DTCs one time, then it will stay on (see example 2).
4. If both a continuous and an intermittent failure occur, both DTCs will be indicated as continuous failures.
5. When the system is normal (no DTC), the SRS indicator will stay on (see example 3).
6. If the SRS indicator comes on continuously without a DTC, there may be a problem with the system.
7. If the SRS indicator does not come on as indicated above, always check for an open or a short to ground in the SCS circuit before troubleshooting the system.

Scheme 207

Scheme 208

Scheme 209

1. Continuous failure, SRS Indicator blinks like this
2. Intermittent failure, SRS Indicator blinks like this
3. Normal (no failure, SRS Indicator blinks like this

Scheme 210

1. Make sure the ignition switch is OFF.
2. Connect the HDS to the DLC (A).
3. Turn the ignition switch ON (II).
4. In the TEST MODE MENU on the HDS, select DTC CLEAR. This erases the DTC(s).
5. Turn the ignition switch OFF, and wait for 10 seconds.
6. Disconnect the HDS from the DLC.