Alternate Adjustment Method
- Install the original shim to the shaft. Use the chassis grease in order to hold the shim in place.
- Install the inner axle housing assembly to the differential carrier case. Do not use sealer at this time.
- Install the bolts and tighten to 40 (30 lb ft).
- Measure the shaft end play using the following procedure: Install the J-8001 dial indicator set or the equivalent on the axle tube end. The plunger of the indicator must be at a right angle to the axle flange. Move the shaft back and forth and read the end play. The correct end play is 0.03-0.51 mm (0.001-0.020 in). If the end play is incorrect, install a thicker or thinner shim as needed in order to bring the end play into the specified range.