REMOVAL & INSTALLATION
| WARNING | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION Section before disconnecting battery. |
Note. If shims are installed between starter and engine, note and record arrangement for installation reference.
- Disconnect negative battery cable. Raise and support vehicle. Remove starter brackets and shields (if equipped). Remove brush end mounting bracket (if equipped). Disconnect electrical wiring from starter solenoid.
- Remove starter mounting bolts. Remove shims and note arrangement for reassembly. Remove starter. To install, reverse removal procedure. Ensure shims are installed in original location. Tighten bolts and nuts to specifications. See «TORQUE SPECIFICATIONS»(ref-58564-S42667937032001011700000) .