REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer system have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION Section before disconnecting battery. |
Disconnect negative battery cable. Squeeze ends of switch bezel housing while pulling switch bezel housing away from door trim panel. Gently pry locking tabs of switch terminal block away from switch. Carefully remove terminal block. To install, reverse removal procedure.
- Disconnect negative battery cable. Remove trim panel pull strap (if equipped), by removing plug on each side of strap and screws underneath. Remove door handle bezel, armrest screws and armrest. Using Door Handle Clip Remover (J 9886-01), remove window handle (if equipped).
- Use Trim Pad Retainer Clip Remover (J 24595-C) and remove retainers from inner door panel. Remove door trim panel. Remove bezel with switches through cut-out in trim panel. Remove nuts holding power mirror to door. Disconnect electrical connector. Remove power mirror assembly. To install, reverse removal procedure. Tighten power mirror mounting nuts to 88 INCH lbs. (10 N.m).
