Home ReviewsRefund
Home/Geo/Metro/Geo Metro I (1989-1997)/Repair manual/Testing & Diagnostics/Engine Controls - Basic Testing: NVH
Contents Wiring diagrams Section: Testing & Diagnostics All sections

Engine Controls - Basic Testing: NVH Geo Metro I

Testing & Diagnostics

NOISE FILTER/CONDENSER

  1. Disconnect negative battery cable. Disconnect electrical connector from noise filter/condenser. Noise filter/condenser is located on ignition coil.
  2. Using ohmmeter, measure resistance between terminals "A" and "B" of noise filter/condenser. (Схема №3) If resistance is not about 2200 ohms, replace noise filter/condenser.
  3. Using ohmmeter, check continuity between terminals "A" and "B" of noise filter/condenser. If continuity exists, replace filter/condenser.

More articles — Engine Controls - Basic Testing