FLOOR JACK
| WARNING | When jacking a vehicle, always set parking brake to prevent vehicle from rolling. On vehicles equipped with a Traction-Lok axle, DO NOT run engine with one wheel off the ground, or vehicle could move. If vehicle is equipped with an under-chassis mounted spare tire, remove wheel or tire carrier before placing vehicle in a high lift position, or chassis may shift suddenly. |
Floor jack may be used under front suspension lower control arms or rear axle. Observe the following precautions
- Never use jack on any part of underbody.
- DO NOT raise entire vehicle at side rail, with jack midway between front and rear wheels, or permanent body damage may result.
- DO NOT allow lifting plate fingers to contact axle cover plate when lifting at rear axle housing.
- If vehicle is equipped with a stabilizer bar, DO NOT lift at rear axle housing.
FRAME CONTACT HOIST
Vehicle may be raised on single-post or twin-post swiveling arm, or ramp-type drive hoist as long as wide hoist adapters are used. (Scheme 2) If using single-post hoist, ensure lifting arms, pads or ramps are positioned at proper lifting points, and adequate underbody clearance is maintained.
If vehicle is to be raised on a twin-post hoist, use caution not to damage suspension, rear axle cover and/or steering linkage components. DO NOT allow lift pads to contact exhaust system components. Position front adapter pads carefully to ensure maximum support under center of lower suspension arms or spring supports as near wheels as possible. Position rear suspension hoist adapters under spring mounting pads or rear axle housing, away from shock absorber or stabilizer bar mounting brackets.
| CAUTION | If single-post hoist is being used, add additional weight on rear end of vehicle before removing rear axle, fuel tank, spare tire or liftgate. This will prevent vehicle from tipping as center of gravity changes. |
