Home/Ford/Probe/Ford Probe II (1992-1997)/Repair manual/Removal & Installation/Engine Controls - Remove/install/overhaul: Other
Contents Wiring diagrams Section: Removal & Installation All sections

Engine Controls - Remove/install/overhaul: Other Ford Probe II

CAMSHAFT POSITION SENSOR

Note. On 1.8L and 2.5L, Camshaft Position Sensor (CMP) is an integral part of distributor and cannot be serviced separately.

FUEL SYSTEM PRESSURE RELEASE

WARNINGALWAYS relieve fuel pressure before disconnecting any fuel injection-related component. DO NOT allow fuel to contact engine or electrical components.

1.8L & 1.9L

Depress retaining latch and remove rear seat cushion. Disconnect fuel pump connections. Start engine and operate until it stalls. Turn ignition off. Reconnect fuel pump. Install rear seat cushion.

2.0L A/T & 2.5L

Remove fuel pump relay, or disconnect Inertia Fuel Shutoff (IFS) switch. Fuel pump relay is located in engine compartment main fuse panel. The IFS switch is located on right side of trunk. Start engine and operate until it stalls. Turn ignition off. Reconnect fuel pump relay or reset IFS switch.

All Others

  1. Remove fuel cap to release fuel tank pressure. Remove relief valve cap. Relief valve is located on fuel supply manifold. Using Fuel Pressure Gauge (T80L-9974-B), release fuel pressure from relief valve (Schrader valve).
  2. If fuel pressure gauge is not available, disconnect electrical connector to IFS switch. For IFS switch location, see INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATION table. Crank engine for 15 seconds to reduce system pressure. Turn ignition off. Reconnect IFS switch connector.
ApplicationLocation
Escort & Tracer
SedanRight Side Of Trunk
WagonBehind Access Door In Right
Rear Cargo Area
Mark VIIILeft Front Of Trunk
MustangRear Center Of Trunk
ProbeRight Side Of Trunk
Sable & Taurus
SedanLeft Side Of Trunk
WagonBehind Access Door In
Right Rear Cargo Area
All OthersIn Trunk On Left Hinge Support Or Behind Trim Panel

INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATION

FUEL LINE CONNECTOR

Note. Three types of fuel couplings are used. See appropriate REMOVAL & INSTALLATION procedure.

SUPERCHARGER

Note. Disassembly of supercharger unit may void warranty. Supercharger cannot be overhauled. Supercharger is serviced by replacement ONLY.

THROTTLE POSITION (TP) SENSOR

Note. On 1.8L & 2.5L, TP sensor is adjustable. For adjustment procedure, see appropriate ADJUSTMENTS article in the ENGINE PERFORMANCE section below. TP sensor is not adjustable on all other models.

  1. «ADJUSTMENTS - 4-CYL»(ref-22872)
  2. «ADJUSTMENTS - V6»(ref-22884)
  3. «ADJUSTMENTS - V8»(ref-22902)