AIR BAG SYSTEM
| CAUTION | Read the following safety precautions before servicing steering column. |
Always wear safety glasses when servicing vehicle with air bag and when handling air bag.
Air bag system must be disabled before servicing any air bag component. See DISABLING & ACTIVATING AIR BAG SYSTEM .
When handling air bag module, ensure bag and trim cover are pointed away from your body. This reduces chance of injury in case of accidental air bag deployment. When placing air bag module on bench or other surface, always face air bag and trim cover up, away from surface. This reduces motion of module if accidentally deployed.
Safety precautions must also be observed when handling a deployed air bag. After deployment, air bag surface may contain deposits of sodium hydroxide, a product of inflation gas generant combustion that irritates skin. Always wear gloves and safety glasses when handling air bag. Wash hands with mild soap and water afterward.
DO NOT probe connectors on air bag module. Air bag may deploy causing personal injury.
DO NOT attempt to service air bag module or contact assembly. To correct system malfunctions, replace complete assembly.
After any servicing, ensure AIR BAG light does not indicate any faults.
DISABLING & ACTIVATING AIR BAG SYSTEM
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
| WARNING | Both driver's side and passenger's side air bag modules must be disabled. |
DISABLING SYSTEM
- Disconnect negative battery cable. Disconnect positive battery cable. Wait one minute. This is the time required for backup power supply in diagnostic monitor to deplete its stored energy.
- Remove bolts retaining driver's side air bag to steering wheel. Disconnect driver's side air bag module electrical connector. Attach Air Bag Simulator (418-F403) to vehicle side of air bag electrical connector. If testing or vehicle operation is required, connect positive battery cable, then connect negative battery cable.
- To disable passenger's side air bag, open glove box door to fullest extent by pushing in on tabs and releasing door. Remove A/C evaporator duct. Through glove box opening, remove 2 passenger's side air bag module bolts. Disconnect passenger-side air bag electrical connector. CAUTION: DO NOT handle passenger's side air bag module by grabbing edges of deployment doors.
- Carefully remove air bag module by pushing on it from inside instrument panel opening. Place air bag on bench, with trim cover facing up. Attach simulator to air bag terminals on wire harness side of air bag electrical connector. If testing or vehicle operation is required, connect positive battery cable, then connect negative battery cable.
ACTIVATING SYSTEM
- Ensure both battery cables are disconnected. Wait one minute. Remove air bag simulators from driver's side air bag and passenger's side air bag wiring harness connector.
- Reconnect driver's side air bag electrical connector to air bag module. Install driver's side air bag module on steering wheel. Tighten nut and washer assemblies to specification. See «TORQUE SPECIFICATIONS»(ref-95138-S25244014862001033100000) .
- Reconnect passenger's side air bag electrical connector to air bag module. Install passenger's side air bag module. Connect positive battery cable. Connect negative battery cable. Check AIR BAG light for system faults.
MULTIFUNCTION SWITCH
Note. Multifunction switch incorporates turn signal, wiper/washer, hazard warning, flash-to-pass and dimmer switch functions.
LOCK CYLINDER (FUNCTIONAL)
Note. If lock cylinder is non-functional (lock cylinder cannot be rotated due to missing key or damaged lock cylinder), see LOCK CYLINDER (NON-FUNCTIONAL) .
LOCK CYLINDER (NON-FUNCTIONAL)
Note. If lock cylinder is functional (key is available and lock cylinder turns freely), see LOCK CYLINDER (FUNCTIONAL) .
SHAFT BEARING
Note. Shaft bearing removal and installation procedures are not available from manufacturer.