TORQUE SPECIFICATIONS
| Description | Nm | Lb-ft | Lb-in |
|---|---|---|---|
| Ball joint nut | 63 | 46 | |
| Wheel knuckle-to-strut bolt | 150 | 111 | |
| Wheel hub nut | 270 | 199 | |
| Wheel speed sensor bolt | 9 | 80 | |
| Tie-rod end nut | 35 | 26 | |
| Strut upper nuts | 30 | 22 | |
| Strut rod nut | 90 | 66 | |
| Brake caliper anchor plate bolts | 133 | 98 | |
| Lower control arm nuts (1) | |||
| Stabilizer bar bracket bolts | 55 | 41 | |
| Stabilizer bar link nuts | 55 | 41 | |
| Steering column shaft bolt | 28 | 21 | |
| Front subframe bolts (Ml 2) | 103 | 76 | |
| Front subframe bolts (Ml 4) | 175 | 129 | |
| (1) Refer to the procedure in this article. | |||
| (1) | Refer to the procedure in this article. |
TORQUE SPECIFICATIONS
| WARNING | All vehicles are equipped with gas-pressurized front struts and rear shock absorbers which will extend unassisted. Do not apply heat or flame to the shock absorber or strut during removal or disassembly. Failure to follow these instructions may result in personal injury. |
| CAUTION | Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation is necessary. Do not use a new part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts. |
The front suspension consists of the following components
- Wheel bearings
- Wheel hubs
- Lower control arms
- Stabilizer bar
- Stabilizer bar links
- Stabilizer bar bushings
- Strut and spring assemblies
- Wheel knuckles
- Subframe assembly
Refer to SUSPENSION SYSTEM-GENERAL INFORMATION .
See also:
• JACKING AND LIFTING