Principles of Operation - Heated Seats
The driver and passenger heated seats share a common ignition feed to the heated seat switches and have separate grounds to the backrest heated seat elements. The heated seat switches are a latching type switch; continuity through the switch will remain whether voltage is supplied to the switch or not until the OFF position is selected. When the heated seat switch is pressed and the ignition switch is in the RUN or START position, voltage is supplied to a bi-metallic switch type thermostat that is part of the cushion heated seat element. The cushion and backrest heated seat elements are wired in series and powered by the same output of the thermostat. Each heated seat switch shows ON and OFF status through its own LED indicator. The heated seat will remain ON until the heated seat switch is pressed to OFF and voltage is no longer supplied to the thermostat. If the ignition source is removed (key OFF), the heated seat will return to an ON state once the ignition source is returned (key RUN) and continue to operate until the heated seat switch is pressed to OFF. The heated seat system is designed to heat the seat to 40°C (104°F) and maintain the temperature by the opening (no voltage to the heated seat elements) and closing (voltage supplied to the heated seat elements) of the thermostat.
Normal Operation
The driver and passenger heated seat switches share common ignition voltage feed to circuit 15-HC1 (GN/BU) spliced to the driver heated seat switch circuit 15-HC6 (GN/YE) and the passenger heated seat switch circuit 15-HC9 (GN/BK). The heated seat switches share spliced ground to circuits 31-LH29 (BK) (driver) and 31-LH43 (BK) (passenger). The heated seat switches are a latching style switch with an LED ON/OFF indicator. Continuity through the switch will remain whether voltage is supplied to it or not until switched OFF. With the ignition switch in RUN or START and a heated seat switch in the ON position, voltage is applied to circuit 15S-HC6 (GN/YE) (driver) or 15S-HC9 (GN/BK) (passenger) and connected to a 2-lead bi-metallic switch type thermostat incorporated into each cushion's heated seat element. Each thermostat is connected by a series circuit to the cushion heated seat element internally. Each seat's cushion and backrest heated seat elements are also connected by a series circuit to ground circuit 31-HC8 (BK) (driver) or 31-HC11 (BK) (passenger). With a heated seat switch ON, the cushion thermostat will cycle OPEN or CLOSED to allow current flow to the heated seat elements and regulate the seat cushion temperature at approximately 40°C (104°F). If a heated seat is ON and the ignition source voltage is removed, the heated seat will enter an OFF state but will return ON when the ignition voltage is restored. The temperature sensor is not a serviceable item and must be installed as part of a new cushion heated seat element.