GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| High Performance DOT 3 Motor Vehicle Brake Fluid PM-1 or PM-1-C (US); CPM-1 or CPM-1-C (Canada) | ESA-M6C25-A or WSS-M6C62-A |
| Silicone Brake Caliper Grease and Dielectric Compound XG-3-A | ESE-M1C171-A |
GENERAL SPECIFICATIONS
FRONT DISC BRAKE SPECIFICATIONS
| Item | Specification |
|---|---|
| Brake Disc | |
| Brake disc minimum thickness | 23 mm (0.905 in) |
| Brake Pads | |
| Brake pad maximum taper wear (in any direction) | 3.0 mm (0.118 in) |
| Brake pad minimum thickness | 3.0 mm (0.118 in) |
FRONT DISC BRAKE SPECIFICATIONS
TORQUE SPECIFICATIONS
| Description | Nm |
|---|---|
| Brake caliper anchor plate bolts | 133 |
| Brake guide pin caliper bolts | 28 |
| Brake caliper hose fitting | 15 |
TORQUE SPECIFICATIONS
The front disc brake system consists of the following components
- Caliper
- Dust seal
- Piston
- Piston seal
- Caliper bleeder screw
- Brake pads
- Anchor plate
- Rotor
- Dust shield
The front disc brake system consists of a single-piston front disc brake caliper and a ventilated front disc brake rotor. The brake pads are held in the front disc brake caliper by 2 front disc brake caliper bolts.
To remove the brake disc shield you must remove the wheel knuckle. Refer to FRONT SUSPENSION article.
Refer to BRAKE SYSTEM - GENERAL INFORMATION article.
See also:
• JACKING AND LIFTING