GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Steering Gear Insulator Bushing | |
| Distance from the bottom of the steering gear housing to the bottom of the bushing | 4.5 mm (0.17 in) ± 0.5 mm (0.01 in) |
GENERAL SPECIFICATIONS
TORQUE SPECIFICATIONS
| Description | Nm |
|---|---|
| Accessory drive belt splash shield bolts | 9 |
| Engine coolant reservoir bolts | 10 |
| Lower steering column shaft-to-steering gear bolt | 28 |
| Lower subframe bolts | 175 |
| Outer tie-rod end nuts | 35 |
| Power steering fluid reservoir bolts | 25 |
| Power steering pressure (PSP) sensor | 20 |
| Power steering pump bolts | 25 |
| Pressure line bracket-to-AC compressor stud nut | 9 |
| Pressure line bracket-to-starter stud nut | 9 |
| Pressure line fitting | 65 |
| Stabilizer bar link upper nuts | 55 |
| Steering gear bolts | 63 |
| Steering line clamp plate bolt | 23 |
| Transaxle roll restrictor bolt | 50 |
| Upper steering column shaft-to-lower steering column shaft bolt | 28 |
| Upper subframe bolts | 103 |
TORQUE SPECIFICATIONS
Note. The power steering pump cannot be disassembled. A new unit must be installed.
Note. The steering gear cannot be disassembled. A new unit must be installed.
The power steering system consists of the following components
- Power steering pump
- Power steering pump reservoir
- Steering gear
- Power steering pressure line
- Power steering return hose
Refer to STEERING SYSTEM - GENERAL INFORMATION article.
See also:
• JACKING AND LIFTING
• SUPPLEMENTAL RESTRAINT SYSTEM