REMOVAL
| CAUTION | Do not remove or repair the brake pedal, brake booster or master cylinder without first removing the speed control deactivator switch. Do not install the speed control deactivator switch without the brake pedal arm secured to the brake booster push rod. Do not pull or push on the brake pedal when removing or installing the speed control deactivator switch, as misadjustment or damage to the switch may occur. |
- Disconnect the speed control deactivator switch electrical connector.
- Rotate counterclockwise 45 degrees and remove the speed control deactivator switch.
INSTALLATION
Note. When installing the speed control deactivator switch it is automatically self-adjusting to the proper position. Do not pull up or push down on the pedal during installation. Initial installation of the speed control deactivator switch allows for one adjustment. If additional adjustments are necessary, install a new switch.
- Install the speed control deactivator switch, and rotate clockwise 45 degrees.
- Connect the speed control deactivator switch electrical connector.
REMOVAL AND INSTALLATION
Note. It is not necessary to remove the driver air bag module during this procedure.
Note. Be careful not to allow the speed control switch electrical connector to fall back into the steering wheel.
- Remove the speed control switch by pulling the switch toward the rear of the vehicle. Disconnect the electrical connector.
- To install, reverse the removal procedure.