Inspection and Verification
- Verify the customer concern.
- Visually inspect the following for obvious signs of electrical damage. VISUAL INSPECTION CHART Electrical Universal transmitter Receiver unit
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, verify the symptom. Go to «Symptom Chart»(ref-270968-S38808521142007111500000) .
Symptom Chart
| Condition | Possible Sources | Action |
|---|---|---|
| The universal transmitter is inoperative | Circuitry Universal transmitter Receiver unit | Go to Pinpoint Test A . |
| The universal transmitter indicator flashes slowly when the programmed button is pressed | The universal transmitter is in train mode The remote transmitter is not programmed to this button | REFER to Universal Transmitter Programming . |
| The universal transmitter indicator flashes rapidly for 2 seconds, then solidly illuminates when the programmed button is pressed | The universal transmitter is programmed to a rolling code signal and the receiver is not synchronized | REFER to Universal Transmitter Programming . |
| The universal transmitter indicator illuminates solidly when the programmed button is pressed | The universal transmitter is programmed to another fixed code device The universal transmitter is not cleared before programming by holding the 2 outer buttons | REFER to Universal Transmitter Programming . |
Symptom Chart