Programmable Module Installation (PMI)
The programmable module installation (PMI) method is used when a new programmable module is installed on the vehicle. It is no longer necessary to command the WDS to gather module option content from the old module. The WDS automatically obtains any available module option content information from the old module during the vehicle ID routine that runs when the diagnostic tool is initially connected to the vehicle. It is important that you connect WDS to the vehicle and allow it to identify the vehicle and obtain configuration data prior to removing any modules.
Item 3: Driver Seat Module Installation Note
- Once the module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module. Refer to «MODULE CONFIGURATION»(ref-194061-S28693549692006011900000) .
Scheme 57
| CAUTION | Prior to removal of the vehicle security module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. Refer to MODULE CONFIGURATION . |
Scheme 58
- Remove the right rear quarter trim panel. Refer to «BODY SYSTEM - INTERIOR»(ref-194071) .
- Remove the components in the order indicated in the following illustration and the table.
- To install, reverse the removal procedure.
Item 3: Vehicle Security Module Installation Note
- Once the module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module. Refer to «MODULE CONFIGURATION»(ref-194061-S28693549692006011900000) .