Home ReviewsRefund
Home/Ford/Explorer/Ford Explorer II (1994-2003)/Repair manual/Engine - 4.0L - Tests W/codes: Diagnosis/Performing Self-Test
Contents Wiring diagrams Section: Engine - 4.0L - Tests W/codes: Diagnosis All sections

Performing Self-Test Ford Explorer II

Engine - 4.0L - Tests W/codes: Diagnosis ~271 words

Performing Self-Test

To perform self-test, turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps

  1. Select VEHICLE & ENGINE SELECTION menu.
  2. Select NEW VEHICLE, YEAR & MODEL.
  3. Select DIAGNOSTIC DATA LINK.
  4. Select PCM - POWERTRAIN CONTROL MODULE.
  5. Select DIAGNOSTIC TEST MODE.
  6. Select KOEO ON-DEMAND SELF-TEST.
  7. Turn ignition on.
  8. Follow operating instructions from scan tool menu.
  9. Record DTCs and perform appropriate circuit test. See «DIAGNOSTIC TROUBLE CODE (DTC) REFERENCE CHART»(ref-131263-S00775652632002010400000) . After test is completed, cycle ignition switch before performing other self-tests or driving vehicle.

To perform self-test, turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps

  1. Select VEHICLE & ENGINE SELECTION menu.
  2. Select NEW VEHICLE, YEAR & MODEL.
  3. Select DIAGNOSTIC DATA LINK.
  4. Select PCM - POWERTRAIN CONTROL MODULE.
  5. Select DIAGNOSTIC TEST MODE.
  6. Select KOER ON-DEMAND SELF-TEST.
  7. Start engine and allow to idle.
  8. Follow operating instructions from scan tool menu.
  9. Record DTCs and perform appropriate circuit test. See «DIAGNOSTIC TROUBLE CODE (DTC) REFERENCE CHART»(ref-131263-S00775652632002010400000) . After test is completed, cycle ignition switch before performing other self-tests or driving vehicle.

To perform self-test, turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps

  1. Select VEHICLE & ENGINE SELECTION menu.
  2. Select NEW VEHICLE, YEAR & MODEL.
  3. Select DIAGNOSTIC DATA LINK.
  4. Select PCM - POWERTRAIN CONTROL MODULE.
  5. Select DIAGNOSTIC TEST MODE.
  6. Select RETRIEVE/CLEAR CONTINUOUS DTCs.
  7. Turn ignition on.
  8. Follow operating instructions from scan tool menu.
  9. Record DTCs and perform appropriate circuit test. See «DIAGNOSTIC TROUBLE CODE (DTC) REFERENCE CHART»(ref-131263-S00775652632002010400000) . After test is completed, cycle ignition switch before performing other self-tests or driving vehicle.