- Connect Breakout Box (T83L-50-EEC-IV), leaving ECA disconnected. Connect digital volt-ohmmeter positive lead to test pin No. 18. Connect negative lead to test pin No. 46. Continuity should be present with throttle at idle position.
- Connect digital volt-ohmmeter positive lead to test pin No. 27. Connect negative lead to test pin No. 46. Continuity should be present with throttle at wide open position. If continuity is not as specified, perform KOEO self-test. See appropriate TESTS W/CODES article in this section.
Contents
Section: Adjustments All sections- A/c Compressor
- Abbreviations
- Accessory Drive Belts
- Adjustments
- Application
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Computer Relearn
- Cooling Fan
- Cooling System (mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Driveline/axles
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Controls - Tests W/codes - 1.9l
- Engine Performance
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Heated Glass/defoggers
- Heater
- Identification
- Manual & Power Steering
- Manual HVAC System
- Manual Trans
- MAP Guidelines
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Oem General Information
- Passive Restraints
- Pin Voltage Charts
- Procedures
- Removal & Installation
- Reset Procedures
- Sensor Range Charts
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Timing Belt
- Transmission
- Wheel Alignment
- Windows
- Wiper/washer Systems
- Wiring Diagrams - Engine Performance