Home/Ford/Escape/Ford Escape I facelift 2 (2007-2012)/Repair manual/Automatic Trans/Automatic Transmission - Electronically Controlled Continuo…
Contents Wiring diagrams Section: Automatic Trans All sections

Automatic Transmission - Electronically Controlled Continuously Variable Transmission (Ecvt): Specifications Ford Escape I facelift 2

MATERIAL SPECIFICATIONS

ItemSpecificationFill Capacity
Motorcraft® MERCON® LV Automatic Transmission Fluid XT-10-QLVCMERCON® LV4.05L (4.28 qt) (1) (2)
Motorcraft® Premium Gold Engine Coolant with Bittering Agent (bittered in US only) VC-7-B (US); CVC-7-A (Canada); or equivalent (yellow color)WSS-M97B51-A13.5L (3.7 qt) approximate dry fill capacity
Thread Sealant with PTFE TA-24WSK-M2G350-A2
(1) Transmission filled for life. (2) The correct transaxle fill level is to the bottom of the fill plug, which is the upper plug.
(1)Transmission filled for life.
(2)The correct transaxle fill level is to the bottom of the fill plug, which is the upper plug.

MATERIAL SPECIFICATIONS

GENERAL SPECIFICATIONS

ItemSpecification
Weight
Engine and transaxle assembly weight251 kg (554 lb)
Transaxle weight130 kg (287 lb)

GENERAL SPECIFICATIONS

TORQUE SPECIFICATIONS

DescriptionNm
A/C compressor connector retainer25
ABS sensor bolt15
Auxiliary coolant pump bolts10
DC-to-DC converter nuts12
Drain plug40
Engine mount bracket nut115
Engine mount bracket bolt115
Engine support crossmember bolts90
Engine support crossmember nut175
Exhaust bracket bolt25
Fill plug40
Intermediate shaft retaining nuts27
Lateral support crossmember bolt115
Lower ball joint-to-knuckle bolt63
Lower insulator bracket bolt90
Lower insulator through bolt115
Motor Electronics Cooling System (MECS) pump bolts20
PCM electrical connector6
Power Transfer Unit (PTU) heat shield bolts14
PTU housing assembly-to-transaxle bolt (10-mm bolt)45
PTU-to-engine support bracket bolts40
Rear insulator bolt80
Rear insulator nuts80
Rear insulator studs12
Rear insulator through bolt115
Rear roll restrictor through bolt90
Rear roll restrictor-to-crossmember through bolt90
Rear roll restrictor bracket bolts55
Selector lever cable bracket nuts23
Stabilizer bar link nut63
Steering column coupling pinch bolt40
Subframe bolts175
Subframe nuts150
Tie-rod end retaining bolt55
Transaxle control snow shield22
Transaxle coolant tube fittings (inlet/outlet)50
Transaxle damper bolts29
Transaxle ground cable nut20
Transaxle harness electrical harness bracket bolts9
Transaxle harness electrical connector stud bolt10
Transaxle NVH shield nuts9
Transaxle NVH shield studs9
Transaxle-to-engine bolts48
Upper insulator bracket bolt25
Upper insulator nuts90
Upper insulator through bolt103

TORQUE SPECIFICATIONS