Window and Glass: Other Ford Escape I

Glass, Frames And Mechanisms

The windshield consists of

1. standard plastic and glass laminate safety glass
2. window opening flange bonded with urethane adhesive The liftgate window consists of
3. standard plastic and glass laminate safety glass
4. heated window grid wire
5. two liftgate window glass hinges
6. two liftgate lifting cylinder anchors
7. window wiper motor and arm
8. striker The front door window consists of
9. standard plastic and glass laminate safety glass
10. manual window regulator crank handle (if equipped)
11. window control switch (if equipped)
12. window regulator assembly which consists of: manual window regulator power window regulator and motor The real- door window glass consists of
13. standard plastic and glass laminate safety glass
14. manual window regulator crank handle (if equipped)
15. window control switch (if equipped)
16. window regulator assembly which consists of: manual window regulator power window regulator and motor The rear quarter window consists of
17. standard plastic and glass laminate safety glass
18. window opening flange bonded with urethane adhesive The window control switch
19. is located on each door trim panel.
20. may be used to raise or lower both passenger side and driver side windows from the window control switch on the driver door.
21. includes a window lock feature that is controlled through the window control switch on the driver door.

Scheme 63

Window Control Switch

Note. The removal and installation procedures for all window control switches are similar.

Scheme 64

1. Remove the front door trim panel or the rear door trim panel.
2. Release the locking clips and remove the window control switch.
3. To install, reverse the removal procedure.

Scheme 65

1. Remove the audio unit.
2. Push outward on the rear window defrost switch to remove it from the instrument panel center finish panel. Disconnect the electrical connector.
3. To install, reverse the removal procedure.

Scheme 66

Scheme 67

Scheme 68

Scheme 69

1. Remove the front door trim panel.
2. Remove the screw and the door trim panel bracket.
3. Position the water shield aside.
4. Remove the front door interior glass weatherstrip.
5. Connect the window control switch to the door harness.
6. Connect the battery.
7. Lower the front door window glass to gain access to the screws.
8. Remove the front door window glass screws.
9. Remove the front door window glass.
10. To install, reverse the removal procedure.

Scheme 70

1. Remove the «rear door glass top run»(ref-177682-S02259338962005060300000) .
2. Remove the rear door window glass.
3. To install, reverse the removal procedure.

Scheme 71

All vehicles

Scheme 72