CAMSHAFT POSITION SENSOR
See CAMSHAFT POSITION SENSOR (CMP) under FUEL SYSTEM.
FUEL SYSTEM PRESSURE RELEASE
| WARNING | Always relieve fuel pressure before disconnecting any fuel injection-related component. DO NOT allow fuel to contact engine or electrical components. |
- Remove fuel filler cap to release fuel tank pressure. Remove relief valve cap. Relief valve is located on fuel supply manifold. Using Fuel Pressure Gauge (T80L-9974-B), release fuel pressure from relief valve (Schrader valve).
- If fuel pressure gauge is not available, disconnect electrical connector to IFS switch. For IFS switch location, see INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATION table. Crank engine for 15 seconds to reduce system pressure. Turn ignition off. Reconnect IFS switch connector.
| Application | Location |
|---|---|
| Contour & Mystique | Behind Left Kick Panel |
INERTIA FUEL SHUTOFF (IFS) SWITCH LOCATION
FUEL LINE CONNECTOR
Note. Three types of fuel couplings are used. Use illustrations to identify proper servicing procedures. (Схема №1)- (Схема №3).
THROTTLE POSITION (TP) SENSOR
Note. TP sensor is not adjustable.