Crankcase Capacity
Oil capacity is 4.5 qts. (4.3L) with oil filter.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|
| A/C Compressor Mounting Bolt | 15-22 (20-30) |
| Alternator Mounting Bolt | 30-41 (41-56) |
| Camshaft Bearing Cap Bolt (1) | 13-15 (18-20) |
| Camshaft Sprocket Bolt | 47-53 (64-72) |
| Connecting Rod Cap Nut |
| Step 1 | 26 (35) |
| Step 2 | Additional 90 Degrees |
| Crankshaft Pulley Bolt | 81-89 (110-121) |
| Cylinder Head Bolt (2) |
| Step 1 | 15-22 (20-30) |
| Step 2 | 30-37 (41-50) |
| Step 3 | Additional 90 Degrees |
| Exhaust Manifold Nuts | 13-16 (18-22) |
| Flywheel Bolt | 81-86 (110-117) |
| Intake Manifold Bolt/Nut | 12-15 (16-20) |
| Main Bearing Cap Bolt (3) | 55-66 (75-90) |
| Oil Pan Bolt | 15-18 (20-24) |
| Rear Seal Housing Bolt | 13-16 (18-22) |
| Torque Converter Nuts | 54-64 (73-87) |
| Transaxle-To-Engine Bolt | 25-34 (34-46) |
| Water Pump Bolt | 12-15 (16-20) |
| INCH Lbs. (N.m) |
| Center Timing Belt Cover Bolt | 53-71 (6-8) |
| Lower Timing Belt Cover Bolt | 53-71 (6-8) |
| Oil Pump-To-Block | 71-102 (8-12) |
| Oil Strainer Bolt | 71-97 (8-11) |
| Spark Plug | 106-156 (12-18) |
| Upper Timing Belt Cover Bolt | 27-44 (3-5) |
| Valve Cover | 53-71 (6-8) |
| Water Pump Pulley Bolt | 89-124 (10-14) |
| (1) Tighten in sequence. (Схема №14) (2) Tighten in 3 steps, in sequence. (Схема №7) (3) Tighten thrust bearing cap bolts last. |
| (1) | Tighten in sequence. (Схема №14) |
| (2) | Tighten in 3 steps, in sequence. (Схема №7) |
| (3) | Tighten thrust bearing cap bolts last. |
GENERAL SPECIFICATIONS
| Application | Specification |
|---|
| Displacement | 121 Cu. In. (2.0L) |
| Bore | 3.35" (85 mm) |
| Stroke | 3.46" (88 mm) |
| Compression Ratio | 9.6:1 |
| Fuel System | SFI |
| Horsepower @ RPM | 125 @ 5500 |
| Torque Ft. Lbs. @ RPM | 130 @ 4000 |
