CYLINDER IDENTIFICATION SENSOR (CID) & CRANKSHAFT SENSOR
CID sensor is mounted at crankshaft. Disconnect sensor connector and measure resistance across sensor terminals. Resistance should be 300-750 ohms. If resistance is not as specified, replace sensor.
IGNITION SYSTEM IDENTIFICATION
Note. For additional information and descriptions see IGNITION SYSTEMS in THEORY/OPERATION article in the ENGINE PERFORMANCE Section. Perform spark output check in BASIC TESTING article before entering these tests. Some ignition systems require that Quick Test procedure be performed prior to testing. This will retrieve trouble codes from the EEC-IV system. See TESTS W/CODES EEC-IV article.
| Acronym | Definition |
|---|---|
| BAT+ or BAT(+) | Battery Positive |
| BAT or BAT(-) | Battery Negative |
| BOB | Breakout Box |
| CBD | Closed Bowl Distributor (TFI-IV) |
| CCD | Computer Controlled Dwell (TFI-IV) |
| CID | Cylinder Identification |
| C1, C2, C3 | Coil Drive (Coils 1, 2 & 3) |
| DIS | Distributorless Ignition System |
| ECA | Electronic Control Assembly (EEC-Processor, Computer, Processor) |
| EDIS | Electronic Distributorless Ignition System |
| DPI | Dual Plug Inhibit (High Signal - Rt Plugs Fire, Low Signal -Both Sides Fire) |
| IDM | Ignition Diagnostic Monitor (Diagnostic Signal to ECA) |
| IGGND | Ignition Ground (Low Current Ground Reference) |
| KOEC | Key On Engine Cranking (Testing Condition |
| KOEO | Key On Engine Off (Testing Condition) |
| KOER | Key On Engine Running (Testing Condition) |
| PIP | Profile Ignition Pickup (Crankshaft Sensor Signal) |
| PWRGND | Power Ground Circuit to DIS Module |
| SAW | Spark Angle Word |
| SPOUT | Spark Output (ECA Spark Control Signal) |
| TFI or TFI-IV | Thick Film Ignition (IV is 4th Generation) |
| VPWR or VBAT | Battery Power or Battery Voltage |
| VRS or VR Sensor | Variable Reluctance Sensor (Crankshaft) |
| (1) Not all circuits and components are used in all systems. | |
| (1) | Not all circuits and components are used in all systems. |
IGNITION SYSTEM ACRONYMS (1)
| Application | System |
|---|---|
| 2.3L Ranger | DIS |
| 2.9L Ranger | TFI-IV |
| 3.0L Aerostar & Ranger | TFI-IV |
| 4.0L Aerostar, Explorer, Navajo & Ranger | EDIS |
| 4.9L Bronco, "E" & "F" Series | TFI-IV |
| 5.0L Bronco, "E" & "F" Series | TFI-IV |
| 5.8L Bronco, "E" & "F" Series | TFI-IV |
| 7.5L "E" & "F" Series | (1) TFI-IV |
| (1) Closed Bowl Distributor (CBD). | |
| (1) | Closed Bowl Distributor (CBD). |
IGNITION SYSTEM IDENTIFICATION
See also:
• FUEL PRESSURE SPECIFICATIONS