Wiring Diagram Information: Overview Dodge Nitro I

IDENTIFICATION

In-line connectors are identified by a number, as follows

1. In-line connectors located in the engine compartment are C100 series numbers.

1. In-line connectors located in the instrument panel area are C200 series numbers.

1. In-line connectors located in the body are C300 series numbers.

1. Jumper harness connectors are C400 series numbers.

1. Grounds and ground connectors are identified with a "G" and follow the same series numbering as the in-line connectors.

1. Splices are identified with an "S" and follow the same series numbering as the in-line connectors. In addition, S001-S099 numbers are located in the engine compartment.

1. Component connectors are identified by the component name instead of a number. Multiple connectors on a component use a C1, C2, etc. identifier.

SECTION IDENTIFICATION AND INFORMATION

The wiring diagrams are grouped into individual sections. If a component is most likely found in a particular group, it will be shown complete (all wires, connectors, and pins) within that group. For example, the Auto Shutdown Relay is most likely to be found in appropriate SYSTEM WIRING DIAGRAMS article , so it is shown there complete. It can, however, be shown partially in another group if it contains some associated wiring.

Splice diagrams in SPLICES show the entire splice and provide references to other sections the splices serves. CONNECTOR/GROUND/SPLICE LOCATION only contains splice diagrams that are not shown in their entirety somewhere else in the wiring diagrams.

CONNECTOR PIN-OUTS shows each connector and the circuits involved with that connector.

See also:
• CONNECTOR/GROUND/SPLICE LOCATION
• CONNECTOR PIN-OUTS