Home/Dodge/Grand Caravan/Dodge Grand Caravan IV (2000-2007)/Repair manual/Automatic Transmission Diagnostic Procedures/SOME DISPLAY ITEMS READ "-"

Contents

Section: Automatic Transmission Diagnostic Procedures

IMPORTANT

NGC CONTROLLER

SYSTEM COVERAGE

SIX - STEP TROUBLESHOOTING PROCEDURE

IDENTIFICATION OF SYSTEM

GENERAL DESCRIPTION

FUNCTIONAL OPERATION

AUTOSTICK FEATURE (IF EQUIPPED)

TRANSMISSION OPERATION AND SHIFT SCHEDULING AT VARIOUS OIL TEMPERATURES.

DIAGNOSTIC TROUBLE CODES

HARD CODE

ONE TRIP FAILURES

INTERMITTENT CODE

STARTS SINCE SET COUNTER

TROUBLE CODE ERASURE

QUICK LEARN

CLUTCH VOLUMES

Possible Causes

EATX DTC EVENT DATA

ELECTRONIC PINION FACTOR (IF APPLICABLE)

USING THE DRBIII®

DRBIII® ERROR MESSAGES

DRBIII® DOES NOT POWER UP (BLANK SCREEN)

DISPLAY IS NOT VISIBLE

SOME DISPLAY ITEMS READ "-"

TRANSMISSION SIMULATOR (MILLER TOOL # 8333) AND FWD ADAPTER (MILLER TOOL #8333-1A)

DISCLAIMERS

TECHNICIAN SAFETY INFORMATION

VEHICLE PREPARATION FOR TESTING

SERVICING SUB-ASSEMBLIES

DRBIII® SAFETY INFORMATION

VEHICLE DAMAGE WARNINGS

ROAD TESTING A COMPLAINT VEHICLE

ELECTRONIC PINION FACTOR WARNINGS (IF APPLICABLE)

BULLETINS AND RECALLS

REQUIRED TOOLS AND EQUIPMENT

ACRONYMS

DEFINITIONS

When Monitored and Set Condition: P0122-TPS/APPS LOW

When Monitored and Set Condition: P0123-TPS/APPS HIGH

When Monitored and Set Condition: P0124-TPS/APPS INTERMITTENT

When Monitored and Set Condition: P0218-HIGH TEMPERATURE OPERATION ACTIVATED

When Monitored and Set Condition: P0562-LOW BATTERY VOLTAGE

When Monitored and Set Condition: P0604-INTERNAL TCM

When Monitored and Set Condition: P0605-INTERNAL TCM

When Monitored and Set Condition: P0613-INTERNAL TCM

When Monitored and Set Condition: P0706-CHECK SHIFTER SIGNAL

When Monitored and Set Condition: P0711-TRANSMISSION TEMPERATURE SENSOR PERFORMANCE

When Monitored and Set Condition: P0712-TRANSMISSION TEMPERATURE SENSOR LOW

When Monitored and Set Condition: P0713-TRANSMISSION TEMPERATURE SENSOR HIGH

When Monitored and Set Condition: P0714-TRANSMISSION TEMPERATURE SENSOR INTERMITTENT

When Monitored and Set Condition: P0715-INPUT SPEED SENSOR ERROR

When Monitored and Set Condition: P0720-OUTPUT SPEED SENSOR ERROR

When Monitored and Set Condition: P0725-ENGINE SPEED SENSOR CIRCUIT

When Monitored and Set Condition: P0731-GEAR RATIO ERROR IN 1ST

When Monitored and Set Condition: P0732-GEAR RATIO ERROR IN 2ND

When Monitored and Set Condition: P0733-GEAR RATIO ERROR IN 3RD

When Monitored and Set Condition: P0734-GEAR RATIO ERROR IN 4TH

When Monitored and Set Condition: P0736-GEAR RATIO ERROR IN REVERSE

When Monitored and Set Condition: P0740-TORQUE CONVERTER CLUTCH CONTROL CIRCUIT

When Monitored and Set Condition: P0750-LR SOLENOID CIRCUIT

When Monitored and Set Condition: P0755-2/4 SOLENOID CIRCUIT

When Monitored and Set Condition: P0760-OD SOLENOID CIRCUIT

When Monitored and Set Condition: P0765-UD SOLENOID CIRCUIT

When Monitored and Set Condition: P0841-LR PRESSURE SWITCH SENSE CIRCUIT

When Monitored and Set Condition: P0845-2/4 HYDRAULIC PRESSURE TEST FAILURE

When Monitored and Set Condition: P0846-2/4 PRESSURE SWITCH SENSE CIRCUIT

When Monitored and Set Condition: P0870-OD HYDRAULIC PRESSURE TEST FAILURE

When Monitored and Set Condition: P0871-OD PRESSURE SWITCH SENSE CIRCUIT

When Monitored and Set Condition: P0884-POWER UP AT SPEED

When Monitored and Set Condition: P0888-RELAY OUTPUT ALWAYS OFF

When Monitored and Set Condition: P0890-SWITCHED BATTERY

When Monitored and Set Condition: P0891-TRANSMISSION RELAY ALWAYS ON

When Monitored and Set Condition: P0897-WORN OUT/BURNT TRANSAXLE FLUID

When Monitored and Set Condition: P0944-LOSS OF PRIME

When Monitored and Set Condition: P0952-AUTOSTICK INPUT CIRCUIT LOW

When Monitored and Set Condition: P0953-AUTOSTICK INPUT CIRCUIT HIGH

When Monitored and Set Condition: P0992- 2-4/OD HYDRAULIC PRESSURE TEST FAILURE

POSSIBLE CAUSE

When Monitored and Set Condition: P1652-SERIAL COMMUNICATION LINK MALFUNCTION

When Monitored and Set Condition: P1684-BATTERY WAS DISCONNECTED

When Monitored and Set Condition: P1687-NO COMMUNICATION WITH THE MIC

When Monitored and Set Condition: P1694-BUS COMMUNICATION WITH ENGINE MODULE

When Monitored and Set Condition: P1775-SOLENOID SWITCH VALVE LATCHED IN TCC POSITION

When Monitored and Set Condition: P1776-SOLENOID SWITCH VALVE LATCHED IN LR POSITION

When Monitored and Set Condition: P1790-FAULT IMMEDIATELY AFTER SHIFT

When Monitored and Set Condition: P1793-TRD LINK COMMUNICATION ERROR

When Monitored and Set Condition: P1794-SPEED SENSOR GROUND ERROR

When Monitored and Set Condition: P1797-MANUAL SHIFT OVERHEAT

When Monitored and Set Condition:P0122-THROTTLE POSITION SENSOR/APPS LOW

When Monitored and Set Condition:P0123-THROTTLE POSITION SENSOR/APPS HIGH

When Monitored and Set Condition:P0124-THROTTLE POSITION SENSOR/APPS INTERMITTENT

DTC P0604: INTERNAL TCM, DTC P0605: INTERNAL TCM, DTC P0613: INTERNAL TCM

When Monitored and Set Condition: P0891-TRANSMISSION RLY ALWAYS ON

TRANSMISSION RANGE SENSOR STATES

PRESSURE SWITCH STATES

SOLENOID APPLICATION CHART

SHIFT LEVER ERROR CODES

TRANSMISSION TEMPERATURE SENSOR (DUAL RANGE)

All sections

SOME DISPLAY ITEMS READ "-" Dodge Grand Caravan IV

Automatic Transmission Diagnostic Procedures

SOME DISPLAY ITEMS READ "-"

This is caused by the scrolling the DRBIII® display a single line up or down. The line which was scrolled onto the screen might read "-". Use the page down or page up function to display the information.