COMPRESSOR OIL DRAIN PROCEDURE
| CAUTION | Be certain to adjust the refrigerant system oil level when replacing an A/C compressor. Failure to properly drain and measure the refrigerant oil from the A/C compressor can prevent the A/C system from operating as designed and cause serious compressor damage. |
The A/C compressor is filled with refrigerant oil from the factory. Use the following procedure to drain and measure refrigerant oil from the A/C compressor.
- Drain all of the refrigerant oil from the old A/C compressor into a clean measured container.
- Drain all of the refrigerant oil from the new A/C compressor into a clean measured container.
- Refill the new A/C compressor with the same amount of refrigerant oil that was drained out of the old compressor. Use only clean refrigerant oil of the type recommended for the A/C compressor in the vehicle.
- Install the new A/C compressor onto the engine. See «INSTALLATION»(ref-285317-S00967597832008052100000) .
Scheme 10
The receiver/drier (1) is mounted in a bracket (2) secured to the right front frame rail (4) in the engine compartment. The receiver/drier is connected between the front section of the liquid line (3) and the rear section of the liquid line (5) between the condenser outlet and the evaporator inlet.