REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Lower window to full down position, if possible. Remove screws attaching trim panel to door. Lift panel up and outward to release retainers. Disconnect door handle linkage and all wiring. remove trim panel. To install, reverse removal procedure.
Note. Power window motor is integral to window regulator unit. If power window motor is faulty, entire window regulator must be replaced.
- Remove door trim panel. See «DOOR TRIM PANEL»(ref-2637-S16797668462000041000000). Remove watershield. Remove inner and outer belt weatherstrip. Lower glass enough to align regulator arm-to-glass nuts with access holes in inner door panel.
- Remove front glass run channel. Remove nuts attaching glass to regulator arm. Separate glass from regulator arm. Lift glass upward and remove from door. (Scheme 1)
- Disconnect window motor wire connector. Loosen bolts in slotted holes attaching window regulator to inner door panel. Remove remaining window regulator mounting bolts. Remove window regulator and motor assembly through access hole in inner door panel. To install, reverse removal procedure.
Scheme 1
Removal & Installation (Dakota)
Disconnect negative battery cable. Using a trim stick, gently pry upper edge of switch bezel to release retainer securing bezel to door trim panel. Pull switch and bezel away from door trim panel and disconnect switch wire connector. To install, reverse removal procedure.
Removal & Installation (Durango)
Disconnect negative battery cable. Remove door trim panel. See DOOR TRIM PANEL . On driver's door, remove screws from back side of door trim panel and remove switch and bezel. On passenger's doors, gently pry snap clips at sides of window switch receptacle on back of door trim panel switch bezel. On all doors, remove power window switch from bezel. To install, reverse removal procedure.
